ICPcable II is cheap In-system programmer for ST7 Flash mcrocontrollers of STMicroelectronics. This programmer is simply hardware interface between microcontroller and developer's host PC, when using ST7 Visual Programmer (STVP7) or ST7 Visual Develop (STVD7) software.

Supported microcontrollers 

Configuration 

ICPcable II programmer is compatible with "ST7 FLASH STICK" of STMicroelectronicsc and it can work with ST7 Visual Programmer - a part of ST7 Toolset. After installation ST7 Tools developer must start ST7 Visual Programmer and cklick "Configure" menu. Then choose "Configure ST Visual Programmer", from "Hardware" list select programmer, for ICPcableII that will be "STICK". Window "Port" let you select your port. From "Programing mode" list, you must select one of the three modes. Depending on "Programming mode" selected, a specific ST7 Flash "Device" list will be displayed. After every programming cycle, you must disconnect the programmer from ICP socket, to start your microcontroller correctly.More information are available in STMicroelectoenics datasheet, ST Visual Programmer application and pdf files at ST7 Toolset directory after installation.

Downolad

• ICPcable II welcome letter   [120 kB]
• ICPcable II user manual   [265 kB]
•  ICPcable II - schematic [35kB]
•  ST7 FLASH STICK user manual v1.1 [682kB] 
• In-Circuit Programming catalog note v1.1 [271kB] 
•  ST7 Toolset  v3.3   [30,9MB] (Visual Programmer 3.3.1 + Visual Develop 2.0.0)
•  ST7 Visual Programmer  v3.00   [5,3MB]

Buy ICPcable II

Price

To programmer are attached:

•  CD-ROM with Usre's manual and last version of ST7 Visual Programmer
•  LPT cable
•  ICC cable (10-wires, flat) to connect programmer to user application 

Note: Net price