Block Diagram | Evaluation Board | Download | Buy MMfpga12

Features 

MMfpga12 minimodules

• Complete, ready to use system based on FPGA
• XC3S200 - Spartan-3 device, 200k system gates / 4320 logic cells
• 32MB (16M x 16) SDRAM memory
• 8MB (4M x 16) Flash memory
• 43 I/O pins + 8 - bit bus
• XCF01S - 1Mbit configuration memory
• Onboard  50MHz generator
• Onboard 1.2V i 2.5V power supplies
• Requires single power supply 3.3V
• LED diodes for status indication
• Onboard JTAG connector with FPGA and configuration memory in chain
• 2 x 40 terminals with 0.1" (2.54 mm) pith, fitting every prototype board
• Small dimensions: 40mm x 56mm
• Available evaluation board and sample software
  

XC3S200 device

• 200 system gates, 4320 logic cells
• 216kb Block RAM memory
• 30kb Distributed RAM memory
• 12 hardware multipliers
• 4 Digital Clock Manager circuits
• 63 I/O pins
• JTAG interface 

Block Diagram

A block diagram of MMfpga12 minimodule is shown on the image below:

All signals of the module are led to two 40-pin terminals with 0.1'' (2.54mm) pitch, which simplifies designing of base boards and allows use of module with prototype boards.

Evaluation Board

In order to facilitate the design of equipment using the minimodule, an evaluation board has been developed (EVBfpga). It includes the following elements:

Socket for MMfpga01/02/11/12 modules
Connector with all terminals of the MMfpga modules
+5V i +3.3V voltage regulators
Power switch
Two RS232 ports with LED diodes
Socket for MMusb245 module
Socket for MMlan03 module
Connector for 2x16 LCD display
6-digit LED display
8 LED diodes
8 push buttons
DIP switch
Buzzer
SD/MMC card connector
Two PS/2 connectors
VGA output

Download

MMfpga12

XC3S200

Spartan 3 FPGAs  Spatran 3 Complete Datasheet

XCF01S

Platform Flash PROM User Guide

Sample Software

MMfpga02 and MMfpga12:

• 7seg display - 7-Seg display test.
• Buzzer - buzzer test.
• LEDs and Switches - switches and LED diodes test.
• LCD - shows text on LCD with use of 4-bit mode.
• VGA - test monitor on VGA. Can be display single color and  saturation changing.
• VGA_LOGO - PROPOX logo on VGA, we can manipulate it.
• VGA_TAPETA - B/W 512x256 wallpaper with company name.

MMfpga12:

• PS2 - read chars form keyboard (chars A-Z) and display it on LCD.
• RS232_PS2 - read chars from keyboard (chars A-Z and space) and display it on hyperterminal.

Flash M28W640 and SDRAM Amic A43L4616 memory test:

• flash_test - connect 7-Seg display and programm chip (flash_test.bit). All segments should be lighting. If not memory don't work properly.
• SDRAM_test - connect 7-Seg display and programm chip (test_board v.1.2.bit). On 7-Seg display you should observe '2' (write), 3 (read) and '0' (OK) or E (error). After 1s all segments should be lighting. You can test LEDs by switches SW7-SW4. Buzzer change his signal tone during test. It is posible to reset chip and start test from begining by dip-switch 8.

 Software
 Flash and SDRAM Memory Test

 Software 

Buy MMfpga12

Note: Net prices